Is there a way, using Scale Rail, to set up so that I have a siding start in the middle of a 6 degree curve, and then right after the switch it would line up so the two tracks are lined up parallel to each other? If so, what pieces could i use to accomplish this. Hopefully that made sense. If not, it's not a huge deal, but it would be nice if i could accomplish it. Also, what is the equivalent of a 0 pnt switch in scale rail, in case I need it to prevent long nodes.

Judging by the lack of replies i should think not, ive not seen any scale rail curved points.

No curved points in the package, I'm afraid.

Cheers!
Marc