Jump to content


Photo

Switch on Curve


This topic has been archived. This means that you cannot reply to this topic.
2 replies to this topic

#1 PerryPlatypus

PerryPlatypus

    Porter

  • Valued Customer
  • PipPip
  • 20 posts

Posted 19 January 2010 - 05:37 PM

Is there a way, using Scale Rail, to set up so that I have a siding start in the middle of a 6 degree curve, and then right after the switch it would line up so the two tracks are lined up parallel to each other? If so, what pieces could i use to accomplish this. Hopefully that made sense. If not, it's not a huge deal, but it would be nice if i could accomplish it. Also, what is the equivalent of a 0 pnt switch in scale rail, in case I need it to prevent long nodes.

#2 salopiangrowler

salopiangrowler

    Stationmaster

  • Valued Customer
  • PipPipPip
  • 152 posts

Posted 15 May 2010 - 11:46 AM

Judging by the lack of replies i should think not, ive not seen any scale rail curved points.

#3 Hack

Hack

    The Big Kahuna

  • 3DTrains Admin
  • 8,076 posts

Posted 16 May 2010 - 01:44 AM

No curved points in the package, I'm afraid.

Cheers!
Marc